TUTORIAL

INSTALLATION INSTRUCTIONS FOR EASY TOOLS

Usually when buying a house or building a new one, the kitchen equipment is already installed, so is the sink. However, if you do not like the pre-assembled basin, during the installation process, you cannot find a good worker or you want to install it yourself, having experience in installation and repair will be extremely helpful. MOIVAONHATOI will guide you on how to install a simple under-counter sink at home.

INSTALLATION PROCEDURES

Steps to install the basin

Sink

Step 1: Take the sink out of the box gently, avoiding scratching and cracking the basin. Then, you use glue and apply the glue evenly around the edge of the cut shelf hole, and at the same time slowly put the sink into the under-table position very carefully, matching.

Step 2: You need to install the pipes in turn on the two pots on both sides, then install the water line. Pay attention to the 2 rubber gaskets at the top and bottom, need to tighten the nut.

Step 3: Proceed to install the siphon set in turn to the 2 siphon pots, not familiar with tightly twisting the rubber gasket and the nut. Insert the overflow drain hose into the perforated position and install the garbage cup.

Step 4: Check the joints, nuts firmly, clean the excess glue, overflow on the face and put the garbage cup in the upper position of the siphon.

Steps to install the faucet part

INSTALLING WASHING TABLES

After installing the basin, wait about 12-24 hours for the glue parts to dry before proceeding to install the faucet part.

Step 1: Drain the water valves for about 3-5 minutes to clean the pipes, then close all valves to avoid water leakage during installation.

Step 2: Install the rubber gaskets into the faucet body and use the foot to install the faucet into the sink through the pre-drilled hole on the table.

Step 3: Install the positioning pad and apply glue at the bottom of the faucet to avoid water leakage. Then twist the nut, bolt tightly, fix the faucet to the basin.

Step 4: Open the water shut-off valves and drain them all the way to check the faucet's clearance to avoid clogging the water line.

Notes:

– Choose the right size of the sink, you should choose the sink first, then measure and cut the stone countertop.

– Choose the right stone countertop, whether placing an under-table sink is successful or not depends on the stone countertop. You should look for high-quality, hard-wearing and high-strength stone countertops.

- Carefully consider the slope of the pot, avoid stagnant water. Thoroughly handle waterproofing.

Above is the process of installing a stone countertop and special notes introduced by MOIVAONHATOI. Hope the article will help you.

See more: 20 models of modern and high-class showers, bathtubs, sinks, and faucets

Comments are closed.

en_USEnglish